Electrical Engineer (Robotics)

Check out this NEW Opportunity with Axient!:


Axient is seeking several Electrical Engineers (Robotics) to support the development, design, test, and manufacturing of electronic Motion Control products and systems. These positions are primarily located in Altadena, CA, with additional locations in Boulder, CO or Hyattsville, MD areas.  Given that these are collaborative, laboratory-based roles, remote or hybrid is not an option. 





What you will do...:


Support a multi-disciplinary project team collaborating on multi-board designs through development, and eventually transitioning a flight-ready product to the manufacturing and test engineering teams. 





Embedded system design, including: Schematic Capture and PCB Layout, Digital, Analog, and Mixed Signal Design





Board-level communication interfaces (I2C, SPI, UART, RS-232, RS-422, RS-485, CAN)





Controlled impedance for high-speed channel design (SpaceWire, 10GbE, SerDes)





Linear and Switch Mode DC/DC Power Conversion





Documentation (Test Procedures & Reports, Interface Control Documents, ECOs)





Design Analysis and Simulation (WCA/WCCA, Reliability, Radiation, Spice)





Cable and Wire Harness Design





Signal and Power Integrity (SI/PI)





Electromagnetic Compatibility (EMC)





Skills you will need...:


Minimum Requirements:





Bachelor’s degree from an accredited technical college or university in Electrical or Computer Engineering and 3+ years of relevant work experience





Eligibility for clearance and/or access in this instance requires US citizenship





Experience with embedded system design, including: Schematic Capture and PCB Layout, Digital, Analog, and Mixed Signal Design





Board-level communication interfaces (I2C, SPI, UART, RS-232, RS-422, RS-485, CAN)





Controlled impedance for high-speed channel design (SpaceWire, 10GbE, SerDes)





Linear and Switch Mode DC/DC Power Conversion





Documentation (Test Procedures & Reports, Interface Control Documents, ECOs)





Design Analysis and Simulation (WCA/WCCA, Reliability, Radiation, Spice)





Cable and Wire Harness Design





Signal and Power Integrity (SI/PI)





Electromagnetic Compatibility (EMC)





Extensive experience in prototype development, debug, and test in a lab environment





Demonstrable experience designing and launching products in regulated environments





 





Qualifications:





Experience designing motion control and electromechanical systems for harsh space environments





EEE-INST-002 and radiation-hardness/mitigation





Failure Modes and Effects Analysis (FMEA)





of technical proposal content and labor/cost estimation





Altium Designer





BS degree in STEM





Familiarity with:





DSP and Microcontroller firmware development in C





FPGA Design (Verilog and VHDL)





System and functional requirements





#CJ